Your water heater is one of the most used and much more costly appliances in your home, and consumes a large involving your energy dollars each month. And experts say regular care and maintenance is essential to protecting your investment and saving on your home heating as well as costs.
Regular flushing of one’s water heater is probably the single most important step you can take to prolong its service life in addition, it save energy. For time, sediments enhance in the bottom of your water heater. These sediments act as a barrier between the flame and the tank, thereby making your heater burn longer and hotter. Partly destructive to the tank, but highly inefficient and will significantly raise your heating costs.
In most regions of the country, the common water heater lasts 3-5 years. Regularly flushing your hot water heater can double living of your hot water heater from 3-5 to 7-10 years. To provide a source costs of replacement running from $700 to over $1200 in some cases, getting the most from your heater is critical in today’s markets. In addition, regular flushing makes your hot water heater run more efficiently and can cut heating costs fifty percent. Depending on the volume of hot water your home uses, that can mean a savings of $20 to over $50 a month.
To drain your water heater, initially you should set the thermostat to pilot (if it is often a gas water heater) or turn the circuit breaker off (if it is definitely an electric heater). Failure to do so could result in overheating and severe damage to the heater. Next, close the water supply valve located more than a water inlet line going into your water heater. Equipped to connect a hose to the drain valve located in the bottoom of the space heater. Open the drain and allow it to play until all of your water has emptied from the unit. Then close the drain. Open the water supply valve and refill the heater tank. You should also open a hot water faucet somewhere indoors and stand there and watch it run for several minutes until water flows out quietly. This will allow air to vent because of the heater and the water lines. Finally, you can turn the thermostat to be able to its regular setting (for a gas heater), or turn the circuit breakers back on (for an electric heater).
Besides regularly flushing your water heater, plumbing experts also advise adding a water treatment system to your dwelling to filter or condition the water so is certainly less corrosive to your plumbing system, particularly in areas which have hard water. For more ways to care for and protect your home plumbing system, contact a licensed, professional plumbing contractor in your area to discuss options and products to fit the bill.
Abacus Plumbing, Air Conditioning & Electrical
The Woodlands, TX
(281) 528-1610